|
Connection seems bit faffy but..
ENET cable connection
Please make sure your Android device supports an ethernet connection and allows to use a static IP address. Otherwise this connection type is not supported.
Connect the ENET cable with your Android device using an appropriate USB to Ethernet adapter.
Connect the cable to the OBD port in the footwell on the driver side in the car.
Enable “Static IP“ in the Android Ethernet settings(“Connections“ > “More connection settings“ > “Ethernet“ > “Configure Ethernet device“ > “Static IP“) and make the following entries:
IP Address: 169.254.250.250
Netmask: 255.255.0.0
Default gateway: 0.0.0.0
DNS address: 0.0.0.0
Disconnect the cable and connect it again to make the changes take effect.
Open the settings in the BimmerCode app and make sure the correct adapter type is selected.
Tap “Connect” on the start screen in the BimmerCode app.
Upon first use a dialog is displayed and you have to allow BimmerCode access to the UBS device. Please confirm with “OK“ and then tap “Connect” again.
|