Quote:
Originally Posted by BlueOnBlue
Hi folks
Just finished coding via bimmercode, to enable the dash display.
Works just fine, even have the option turned on for 'lane change assist' in the settings now, but obviously it doesn't work because of the SAS module being uncoded to allow it
Again I used bimmercode in expert mode to enable all the dash functions, and now my question;
I also have the coding cable and Esys software , and when I tried to do that route for coding discovered because I don't have the 3.0 launcher (my understanding is the author has stopped responding to people trying to buy the software) , so all I get when I load the existing 'free' launcher is a load of nonsense I can't understand
From my reading the 'launcher' is what makes the config of the car legible by normal people so they can code it properly.
Do anyone have a way to find certain coding ; specifically to make this change
SAS2 > CAFD_42C1 > C_SWA_VORHANDEN
Default: Nr000_nicht_vorhanden
Change to: NR001_VORHANDEN
Without the 3.0 launcher (basically reading it verbatim from the car)
Cheers
|
Easy - buy esysx. Job done