Quote:
Originally Posted by RSnic
@VipinLJ ,
Two ideas for your consideration:
• You can get an OBDII scanner. I have OBDLink MX+ for coding, along with Bimmercode-- it's OK. The scanner comes with an App that can read & clear codes.
• You can get a copy of ISTA/D. Probably best is to go to the Bimmerfest forums-- but am not sure if that works on G20s?
Hope that helps
|
Thank you very much sir.
I have the OBD2 scanner as well as the enet cable. I just didn’t know if the supplied software would work since I remember reading it only supported F30 and didn’t mention G20 (my memory could be wrong). I have bimmercode (full version) but mine doesn’t read errors (unless I’m missing something).
And I will check it out on bimmerfest. I did reply to a thread in the f30 section at the fest but no one responded yet. I’ll dig deeper.
Thank you once again!