Hi,
I have seen your pdf. But i am unable to unclip it. Do u push the screwdriver from the top to release the trim? Any risk of breaking anything? Do you have a close up photo on the clips of the trim you took out?
Quote:
Originally Posted by Xsapper
If you are talking about the trim around the gear selector then I would say this for me was the hardest part to remove because of the two clips as marked at the dashboard end. All I would say is do not lift the trim too high and use a long thin screw driver to carefully unclip, it did eventually pop out. If you haven't seen it I have done a basic guide in the DIY section.
|