|
My cravenspeed arrived yesterday. I was able to install and after about 5 mins or so of adjusting, was able to get it to work without triggering the sensor. I did want the plate to be a bit more front facing, so I then bought a washer and am using the larger hole to move the plate a bit more center and more front facing. This worked pretty well and no sensor issues.
The only bummer is that while I was adjusting it, the plate did lose its hold and rotated - slicing a small gash in my PPF. I’ll get it fixed, but annoying for sure.
The other note is the cravenspeed uses imperial screws to fashion the plate to the holder. I ran to Home Depot to find the bolts in black, but they did have them. Going to get them from a local hardware store or amazon on Monday.
|