Quote:
Originally Posted by RSnic
@TheGrok ,
Because you are coding DME_BACKUP (which controls some engine functions), the engine turns off -- I had the same thing happen.
What I discovered is that, using E-Sys, I do everything up to turning TSA_MEMORY to aktiv, then BEFORE I tap the CODE button, I turn engine off.
If, on the other hand, you use Bimmercode, you don't have engine running, just car in diagnostic mode (3 quick pushes on Engine Start button WITHOUT pushing down on brake)
As I said, I made same mistake. I haven't noticed any problems except that ASS always switches off when I unlock & open driver's door (I have coded car to start in EcoPro). Having said that, oddly ASS stays off going into & out of the other driving modes.
Hope that helps!
|
Thanks a lot for tip. I will try that with ESYS. So the coding error was because the engine was running? I thought engine always had to be on for coding, but I guess maybe that is for the battery. I am totally new at this coding thing.