Quote:
Originally Posted by DaveDee
See my previous post, I uploaded a proper wiring schematic (along with a video of the converging LEDs), from the video it’s possible to transpose the Can low and Can high.. Also possible to bend pins and not psh the connector back properly or not push the 4 pin connector home on the module
|
Thanks. I think I might have used that schematic when I installed IIRC.
I think I’m getting power being drawn by something, and just want to rule this out by temporarily removing it.
Don’t suppose you know if there would be any problems in doing so? I’m guessing I’ll lose the m track display on sport mode, the dev gauge on HUD, and maybe even the converging LED towards the rev limit.