[Stril]

Hey everyone,

I’m thinking about getting a partial PPF (paint protection film) installation — for example, just the front of the car or some high-impact areas.
I’m wondering: are the edges or transitions between the protected and unprotected paint visible, especially after some time has passed?

Do these lines become more noticeable due to dirt buildup, UV aging, or polishing?Would you recommend going for full-body coverage instead to avoid visible transitions?

Thanks in advance for sharing your experience!

[Portimao Blue M440ix]

Yes, more visible over time. Where you can why not do like full front so no seems and leave the edges for the high impact area. In the high impact areas its either stone chips or PPF edge which can you live with. I wonder if in the high impact areas your referring to can they not wrap the whole panel?

[Stril]

Just to clarify — I don’t mean partially wrapped areas like only the front-part of the hood.In my case, the whole hood would be covered with PPF, but the doors (and the rest of the car) would remain without film.

[dudley@07726]

Remember that the PPF'd and non PPF'd areas may age differently.

[Stril]

How do you handle this, if you do not go „full-wrapped“

[ppointer]

I have been PPF'ing the front of my cars since 2007. What I have found is that around year 12 or so, the PPF begins to yellow and crack. When that happens, it normally costs $150 per hour for roughly three hours work to remove the old stuff, and then I gotta pay again for the new PPF. However, the vehicles look new again, so no regrets.

I only recently started adding ceramic coating to my cars when getting PPF. Whether ceramic or not, I did not have issues with the edges. Certainly I see them, but for me a fair trade to keep the front looking good.

I have only ever purchased Xpel for PPF. I believe if I go with quality products, I'll see good, long-lasting results.

At this point I only have two cars with no ceramic -- a 2001 and a 1967. The 2001 has PPF, so I may get the paint corrected and add ceramic. The 1967 could probably use a paint job in a couple of years, so I'll worry about PPF / ceramic when I get to the paint.

[Redd]

PPF will always collect dirt along the edges. So always insist on a custom cut job where the wrap the ppf over the edges. Pre-cut PPF usually stop short of the edge (saves a lot of time/effort for the installer) and that edge will turn brown/dirty over time.

All PPF will turn yellow with age and UV exposure. I absolutely would not recommend wrapping a white or light colored car. This yellowing will also cause a color disparity between wrapped and unwrapped panels after some time.

[JoeyO]

On two cars, I had PPF put on only the front bumper and headlights. That’s all. And they looked perfectly fine. Nobody could tell PPF was on there. I think the discoloration issue only happens after a long period of time and the color of the paint matters a lot. I had PPF on the front bumper of my silver Audi for 12 years and I never noticed any discoloration.

[Phillies8008]

Originally Posted by ppointer

I have been PPF'ing the front of my cars since 2007. What I have found is that around year 12 or so, the PPF begins to yellow and crack. When that happens, it normally costs $150 per hour for roughly three hours work to remove the old stuff, and then I gotta pay again for the new PPF. However, the vehicles look new again, so no regrets.

I only recently started adding ceramic coating to my cars when getting PPF. Whether ceramic or not, I did not have issues with the edges. Certainly I see them, but for me a fair trade to keep the front looking good.

I have only ever purchased Xpel for PPF. I believe if I go with quality products, I'll see good, long-lasting results.

At this point I only have two cars with no ceramic -- a 2001 and a 1967. The 2001 has PPF, so I may get the paint corrected and add ceramic. The 1967 could probably use a paint job in a couple of years, so I'll worry about PPF / ceramic when I get to the paint.

A lot of installers will remove the old PPF at no charge if you're buying a new install from them. Worth asking, at the very least.