11-26-2021, 07:09 PM | #1 |
Lieutenant
435
Rep 524
Posts |
20” Vossen HF-5 Gloss Black
Vossen HF-5 in Gloss Black and wrapped in Conti ECS
-20X9 f (235/35/20) -20X10.5 r (275/30/20) Car is also dropped on Dinan Springs. Love the wheels - its like falling in love all over again with your car. |
11-28-2021, 08:16 PM | #2 |
Lieutenant
218
Rep 410
Posts |
Looks awesome, excellent wheel choice!
__________________
2020 M340i xDrive - Mineral Grey Metallic/Cognac - MG Flasher Stage 2 OTS 93 | XHP Stage 3 | AA DP | Valvemaster | MST
2008 Infiniti G37S Coupe 6MT - Black/Black IG: jpowers36 |
Appreciate
0
|
12-01-2021, 08:19 AM | #4 |
Captain
239
Rep 978
Posts |
Wheels
Combat and race look is always a good thing.
__________________
2021 M340i
2020 X3 M40i - her car 2019 M5, AW, DP's, MSR CAI, BM3, SOLD 2020 Chev. ZR2 Bison truck, Daily Driver |
Appreciate
0
|
12-03-2021, 10:21 AM | #5 |
New Member
8
Rep 28
Posts |
Do you rub when driving? How is it with street bumps and is there a difference from oem springs?
|
Appreciate
0
|
12-06-2021, 07:45 AM | #6 | |
Lieutenant
435
Rep 524
Posts |
Quote:
It’s actually not bad at all, I have my tire pressure set at 40psi; with the 20’s its obviously going to be a bit stiffer when compared to the stock 19’s, but I would not say its a big difference. Overall I’m quite happy - the pros in this case far outweigh the cons. No rubbing with my setup at all. Though I did attempt to install the rears without the 7mm spacer and it rubbed. That being said, even if the rear didn’t rub without the spacers, I would’ve thrown them on as there is a very slight poke with them on, which looks fantastic. Last edited by GD1981; 12-06-2021 at 07:51 AM.. |
|
Appreciate
0
|
12-20-2021, 06:03 PM | #7 |
Lieutenant Colonel
891
Rep 1,521
Posts |
Hey brother, you by chance have any additional side profile shots of your car in daylight hours? I am contemplating a very similar set up; what spacers do you have installed (Dinan)?
|
Appreciate
0
|
12-21-2021, 07:52 AM | #8 | |
Lieutenant
435
Rep 524
Posts |
Quote:
Future classic 12mm spacer for the front Dinan 7mm spacer for the rear |
|
Appreciate
4
|
12-21-2021, 04:20 PM | #9 |
Lieutenant Colonel
891
Rep 1,521
Posts |
Appreciate the pictures and the information brother! Couple of additional questions:
1) What is the reason you installed a set of Future Classic spacers in the front vs installing Dinan on all four corners? 2. Can you provide the details on the CF front lip and rear spoiler. Thank you again for your time! |
Appreciate
0
|
12-24-2021, 11:30 AM | #11 | |
Lieutenant Colonel
891
Rep 1,521
Posts |
Quote:
https://g20.bimmerpost.com/forums/sh...686702&page=12 -20X9 ET32 (Front) (Tire Size - 235/35/20) -20X10.5 ET45 (Rear) (Tire Size - 275/30/20) |
|
Appreciate
1
Transfer5254.00 |
12-28-2021, 09:45 AM | #13 | |
BMW Enthusiast
170
Rep 221
Posts |
Quote:
As an example I went with the same wheel on mine but a little different tire size with the PS4S.... Vossen HF-5 Matte Gunmetal Front 9x20 Rear 10.5x20 Pilot Sport 4S Front 245/35/20 Rear 285/30/20 I wrote to Michelin and asked them what psi I should run the new tires at. Here was their response... We show based on the OE tire size of 225/40ZR19Rf and OE pressures of 39 psi front and 42 rear, the new pressures for the front tires will carry a similar load at 35 psi front and 26 psi rear! However, we are only allowed to recommend the OE pressures, even though, you replaced your tires with a staggered fitment. Using the lower pressures could cause the TPMS light to come on and you may need to have it re-calibrated! Sincerely, Executive Response Team |
|
Appreciate
0
|
12-28-2021, 09:59 PM | #14 |
Lieutenant
435
Rep 524
Posts |
Sorry for the late response.
In regards to the wheel offsets, I’m running the following: et 32 in the front with a 12mm FC spacer (effective +20) flush et 45 in the rear with a 7mm Dinan spacer (effective +38) ~5mm poke Future Classic doesn’t have a 7mm spacer is the reasoning why I went with Dinan for the rear. IMO Future Classic makes the best spacers - and I’ve tried a handful over the years, though they are on the pricey side. In regards to the tire pressure, I’m running 38 psi all around - I did recalibrate the system, so there is no light on the dash. From all the research I have done regarding this, I’ve seen mixed opinions. As it is now, I like how the car runs. What psi are you running?? Last edited by GD1981; 12-28-2021 at 10:10 PM.. |
Appreciate
1
Chubbiejones891.00 |
12-29-2021, 06:07 AM | #15 | |
BMW Enthusiast
170
Rep 221
Posts |
Quote:
30 rear |
|
Appreciate
0
|
01-01-2022, 10:55 AM | #16 |
Joint Chiefs of Staff
24193
Rep 190,805
Posts |
Looks great
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
01-06-2022, 09:19 AM | #18 |
BMW Enthusiast
170
Rep 221
Posts |
|
Appreciate
0
|
01-10-2022, 10:41 AM | #19 |
Lieutenant
435
Rep 524
Posts |
|
Appreciate
0
|
01-10-2022, 11:19 AM | #20 |
BMW Enthusiast
170
Rep 221
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|