h&r springs install

pgum · 04-07-2024, 06:42 PM

I am currently installing h&r lowering springs on my 2020 330i rwd and I am at the step where I need to remove the bolts that hold the knuckle and shocks. I have taken off the nuts from both and slid out the bolt that holds the shocks, but I can't seem to align the holes to take out the bolt that holds the knuckle. Any advice ?

Throatpunch · 04-07-2024, 09:51 PM

Use the jack to slightly lift and add pressure to the bottom of the hub. It will release friction on the bolt and they can slide out. Be very careful

04-07-2024, 06:42 PM	#1
pgum Registered 0 Rep 3 Posts Drives: bmw 330i Join Date: Apr 2024 Location: georgia iTrader: (0)	h&r springs install - can't align bolts I am currently installing h&r lowering springs on my 2020 330i rwd and I am at the step where I need to remove the bolts that hold the knuckle and shocks. I have taken off the nuts from both and slid out the bolt that holds the shocks, but I can't seem to align the holes to take out the bolt that holds the knuckle. Any advice ?
	Appreciate 0 Tweet Quote

04-07-2024, 09:51 PM	#2
Throatpunch Captain 365 Rep 674 Posts Drives: 2008 E93 M3 Join Date: Jun 2010 Location: Philly, PA iTrader: (0)	Use the jack to slightly lift and add pressure to the bottom of the hub. It will release friction on the bolt and they can slide out. Be very careful
	Appreciate 0 Quote